Home » MODDING HQ 1.13 » v1.13 Bug Reports » Problem with APs and inventory
Re: Problem with APs and inventory[message #324810] Fri, 06 September 2013 09:43 Go to previous messageGo to previous message
JMich is currently offline JMich

 
Messages:546
Registered:January 2011
Location: Greece
 moki
I don't remember exactly what weapon it was, but the attachement was a 4x ACOG scope and I had APs for inventory manipulation enabled (if that matters).
I encountered this problem for the first time now and was a little confused that it never happened before. I'll try to reproduce it and get some exact data. Maybe it does still happen under very specific circumstances.


The AP Manipulation code does not check if you will have enough AP to put the item somewhere. It only checks if your current APs are more than the AP cost of moving the item, and if they are less, prevents dropping of the item. Until someone corrects it, not sure how to fix it. You could try setting APs to drop an item to 0, but that is the same value used to pick an item up, not to mention you will still use some APs, depending on which slot you picked the item from.

Report message to a moderator
First Sergeant
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: tilecache folder missing in 1.13 GameDir
Next Topic: [Fix] Catched the mobiles
Goto Forum:
  


Current Time: Sat Nov 30 02:33:41 GMT+2 2024

Total time taken to generate the page: 0.00992 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software