Home » MODDING HQ 1.13 » v1.13 Bug Reports » Problem with APs and inventory
Re: Problem with APs and inventory[message #324776] Thu, 05 September 2013 10:09 Go to previous messageGo to previous message
silversurfer

 
Messages:2791
Registered:May 2009
Kriplo

However similar bug exist with removing and reloading ammo clips in both screens. Already fix both problem and will update tomorrow after more testing.


I think that I ran into such a problem before while reloading a shotgun. Usually it would just have reloaded but I had only few APs left. I clicked on the gun with the ammo at hand cursor (a 4 shot clip of buckshot) and it loaded one or two shells until I ran out of APs. So I was stuck with 0 APs and some shells still in hand. I couldn't put them back into inventory so I kept clicking on the gun and finally ended with a full gun and -x APs. Looked like a good solution to me at that time. Is that what you are referring to?

There also is some problem with swapping items in inventory. For example if you try to swap your weapons and you have little APs left.

Let's say you want to switch from the rifle in your hand to the SMG in your weapon sling and you have 20 APs left.

1. pick the rifle from hand slot
2. click on the weapon sling slot, now you have the SMG at your cursor and 8 APs left

8 APs is not enough to put that SMG anywhere. You will have to Alt+x to get out of this situation. Sad

I haven't looked closer at this problem though.

Report message to a moderator
Lieutenant
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: tilecache folder missing in 1.13 GameDir
Next Topic: [Fix] Catched the mobiles
Goto Forum:
  


Current Time: Mon Dec 02 02:22:07 GMT+2 2024

Total time taken to generate the page: 0.00755 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software