Home » MODDING HQ 1.13 » v1.13 Modding, Customising, Editing » v1.13 Time Capsule (How-to Library) » How to create face sti's [the basic tutorial]
Re: How to create face sti's [the basic tutorial][message #9464] Wed, 25 August 2004 09:40 Go to previous messageGo to previous message
Khor1255 is currently offline Khor1255

 
Messages:1817
Registered:August 2003
Location: Pleasantville, NJ
Well, I thought I read you're walkthrough pretty good but I'm now having problems with the xy coordinates.
You said make sure all the cutouts are the same size. What I did was to take my full face picture and make two 'templates' from the eye section then the mouth section. Then I altered three mouths and four eyes to the desired expressions (really pretty easy using clone and Special Effect warp). When I placed them in Ira's face file (59) the eyes were too big and offset to the left and high, the mouth just off to the left. Then I did something really stupid and tried to fix it in proedit. It fixed it allright. Now the big image is screwy too.
I'm working first with the 48x43 image. I maybe should have matched the size of the stis from Ira's file? I just thought if I make them all the same size as one another it would work but it hasn't.

Report message to a moderator

Sergeant Major
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Next Topic: 1.13 Map Editor Guide
Goto Forum:
  


Current Time: Tue Dec 03 10:21:29 GMT+2 2024

Total time taken to generate the page: 0.01821 seconds