Home » SIRTECH CLASSICS » Jagged Alliance 2 » JA2 Technical Department » Autofire
Re: Autofire[message #11748] Thu, 15 September 2005 20:10 Go to previous messageGo to previous message
Snap is currently offline Snap

 
Messages:286
Registered:September 2000
Location: USA (by way of the Old Wo...
@Khor: Well, since most weapons with a fixed burst group have it at 3 rounds, you could set the fixed burst to 3 rounds for most automatic weapons. Squeezing less than 3 shots on full auto is difficult anyway, so I think it won't be much of a realism sacrifice to leave out this option. The upshot: you will be able to fire 3-round bursts in the Burst mode, and 3+ -round bursts in the Autofire mode. How does this sound?

Perhaps we could even make fixed burst an option? Most automatic weapons, especially the older ones, don't have this feature anyway. Having automatic mode only means you won't be able to precisely control the burst length, which adds realism and some diversity to weapons.

Quote:
Originally posted by Majek:
Valid points but if we're fixing autofire, then G11's burst might as well harcoded back to the way it was while autofire should be like by other rifles.
that's because it fires the 3round burst at around 2000rpm while if in auto it's only 600rpm.
With my scheme you can do exactly that - no hardcoding needed. If you set the burst APs to 0 for the G11, it will fire the first 3 rounds at no additional cost WRT single shot, but if it also has autofire enabled, then subsequent shots will be fired at the rate specified by bAutofireShotsPerFiveAP. The only problem is that you can only specify one burst penalty, so if it has burst penalty 0 for the fixed burst, it will still be 0 for autofire.

Report message to a moderator

Master Sergeant
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Trying to Copy/Paste Gaston/Stogie/Tex From JA2UB Onto MERC in JA2 - help! :)
Next Topic: Silencers
Goto Forum:
  


Current Time: Mon Jan 20 18:54:42 GMT+2 2025

Total time taken to generate the page: 0.00960 seconds