Home » SIRTECH CLASSICS » Jagged Alliance 2 » JA2 Technical Department » need help with wilfire installation
Re: need help with wilfire installation[message #231054] Fri, 14 August 2009 05:44 Go to previous messageGo to previous message
Kaerar is currently offline Kaerar

 
Messages:2021
Registered:January 2003
Location: Australia :D
 Ok well as far as I know the install procedure is this.

1) Install JA2 from CD (gold or original).

2) If original patch up to 1.06 or 1.07.

3) Install the latest SCI (available from my sig).

4) Install the Wildfire mod components. Easiest way is to overwrite the Data-1.13 information as then it will run without messing about with the Virtual File System (VFS).

5) Install Smeagols Item Mod (again over the Data-1.13 directory). Then you should have a working version Smile

Report message to a moderator
Lieutenant
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 1280x1024, possible ?
Next Topic: problem with map editor
Goto Forum:
  


Current Time: Tue Feb 11 18:58:31 GMT+2 2025

Total time taken to generate the page: 0.00886 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software