Home » SIRTECH CLASSICS » Jagged Alliance 2 » JA2 Technical Department » need help with wilfire installation
Re: need help with wilfire installation[message #231030] Fri, 14 August 2009 00:30 Go to previous messageGo to previous message
Headrock

 
Messages:1760
Registered:March 2006
Location: Jerusalem
 It's complicated. Here's one way I'm pretty sure would work:

1) Install JA2 and patch it up to 1.12
2) Use the latest One-Click Installer to install JA2 1.13 on top of that.
3) Install "Wildfire 6.06 for JA2 1.13" into the directory \Data-1.13\ (some files need to go into \data\, pay attention to the readme file)
4) Install HAM 3.5 into \Data-1.13\, overwriting if necessary.

There's a lot of potential for mistakes, so be very careful. If you do it correctly, this SHOULD work though.

Report message to a moderator
Sergeant Major
[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: 1280x1024, possible ?
Next Topic: problem with map editor
Goto Forum:
  


Current Time: Tue Feb 11 14:30:29 GMT+2 2025

Total time taken to generate the page: 0.00956 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software