Home » SIRTECH CLASSICS » Jagged Alliance 2 » JA2 Technical Department » How can I access IMP Merc .edt files?
How can I access IMP Merc .edt files?[message #10951] Mon, 15 August 2005 05:07 Go to next message
Maddog is currently offline Maddog

 
Messages:311
Registered:September 2003
I want to get my hands on the custom mercs .edt files, because I want to make my own voice for the IMP Merc. The mercs face number is 203, so I assume that the .edt file is called 203.edt, but where can I find it? (and the voice files, naturally)

I'm using Wildfire.

Report message to a moderator

Master Sergeant
Re: How can I access IMP Merc .edt files?[message #10952] Wed, 17 August 2005 07:00 Go to previous messageGo to next message
Khor1255 is currently offline Khor1255

 
Messages:1817
Registered:August 2003
Location: Pleasantville, NJ
Maddog, the speech for IMP mercs is contained in the Merc.edt file under the number that corresponds to their voice number in Proedit not their picture number.

In other words:


051.edt = IMP male voice 1
052.edt = IMP male voice 2
053.edt = IMP male voice 3

054.edt = IMP female voice 1
etc.

Although I don't know for sure, this should be the same in Wildfire since changing this would have been totally uneccessary.

Hope this helps.

Report message to a moderator

Sergeant Major
Re: How can I access IMP Merc .edt files?[message #10953] Wed, 17 August 2005 07:06 Go to previous message
the scorpion

 
Messages:1834
Registered:September 2004
Location: CH
it was changed in Wildfire 6 though

Report message to a moderator

Sergeant Major
Previous Topic: JA2CME1.02 error
Next Topic: JA2 BETA Editor - where?
Goto Forum:
  


Current Time: Sun May 19 02:30:36 GMT+3 2024

Total time taken to generate the page: 0.00911 seconds